Exercising, especially running, is essential to us, but sometimes we are unable to go outside every day due to weather conditions, or seasonal diseases that spread in the street air.
Therefore, running at home through the treadmill ( especially the Carnally electric treadmill ) is a lifesaver, because it is one of the most efficient and most famous treadmills in the world.
But sometimes we encounter some malfunctions of the Carnelian walker while using it, these problems are very easy to solve.
Just follow the steps below for each issue you encounter, making sure you follow the first step well and then move on to the next; Because the problem may go away by applying the first step.
1. The Karnali treadmill does not work
Follow these steps in order:
- Make sure that it is directly connected to the electrical socket, or if it is not connected to the electrical socket.
- Enter the security key on the screen.
- Ensure that the signal circuit system is not broken, by checking the control board and signal cable.
- Replace the fuse, if the fuse is confirmed to have burnt.
2. The Carnelian belt does not work well
The solution to this problem is very simple, just adjust the belt, so that it is not too tight or loosened.
To make sure, lift the belt from the center. If the gap is 2 to 3 inches, that's fine.
3. A problem with the connection of the engine control board to the sensor control board
Most likely, here the malfunction comes from the sensor itself, so do the following:
- Make sure the wires are well connected and replace the damaged ones.
- Replace the computer as it may be the cause of the problem.
- Replace the motor or control unit; Because the problem may be due to one of them.
4. Determination of motor overload
It is one of the most famous Carnegie walker malfunctions, and the solution here is to replace the motor; Because it is most likely damaged.
5. Motor excessive absorption
The solution here is to check the engine and the engine board, and then replace one or both of them in case it is confirmed that it is damaged.
6. Absence of a speed signal in the Carnelian treadmill
- Check the speed sensor, make sure it is in the correct position, then replace it if it is damaged.
- Inspect the power cord, and if damaged, replace it.
- Change the treadmill speed.
- Replace the speed sensor.
- If the problem persists, replace the motor or control unit.
7. Body Fat does not read the pulse signal
It's one of those annoying Carnegie Walker malfunctions, but the solution is very simple:
- Wet your hands when holding the sensors.
- Connect the pulse sensors well.
- Replace cables and heart rate monitors, if damaged.
8. Power problems of the Carnelian treadmill control unit
And here there are no solutions other than replacing the control panel.
9. There is no safety switch in the Carnelian treadmill
This problem is that the computer does not receive the signal from the security key, and the solution is:
- Verify that the security key has been inserted, then replace it if it is confirmed that it is damaged.
- Repair or replace the main computer.
10. Tilt drive signal problem
This problem is that the controller cannot check the signal from the ramp motor ( VR signal ).
The solution here is to check the VR wire and connector, replacing the tilt motor.
And with this, I have solved most of the problems with the Carnelian walker, just stick to the steps shown for each problem, and then enjoy your favorite sport, and do not stop.